Опытный завод

Atritor Limited operates a fully-equipped pilot plant facility in Coventry. The plant has just undergone an extensive refurbishment to improve operating efficiency and increase production capacity for large-volume trials.

Primary Production Equipment

	Сушильно-Дробильный Агрегат Atritor 8A
	Twin-shaft dryer-pulveriser with a wide range of alternative internal assemblies.
	Мельниц Секционного Типа CM500
	Высокоэффективный механический мельница с семью сменными ротора модулей и опциональный классификатор.
	Dynamic Classifier Mill DCM300
	Versatile milling solution with internal classifier. Alternative rotor and classifier arrangements available.
	Сушильно-Дробильный Агрегат Atritor 1B
	Small 'B'-series dryer-pulveriser with alternative internal configurations possible.
	Micronising Mills M2, M3, M4 and M8
	Spiral jet mill for producing super-fine products, with a range of internal configurations available.
	Воздух Стреловидности Трубчатые Сушилки AST2010
	Capable of drying almost anything, from low-solids slurries to low-moisture powders.
	Турбо-Сепаратор TS2096
	Conveyor-fed with many alternative internal configurations possible.

Ancillary Plant and Equipment

In addition to the primary equipment listed above, Atritor's test facility is also equipped with the following plant:

	Stand-alone classifier
	Full range of feeding and back-mixing equipment
	Product collection cyclones and filters
	Gas-fired and electric air heaters
	Oil-free compressor

Analytical Laboratory Equipment

Atritor's pilot plant also includes a laboratory to allow immediate analysis of product samples.

	Malvern Instruments MasterSizer S dry particle size analyser
	Air jet sieving machine
	Wide range of standard mechanical sieves
	Moisture balance for determining moisture content